My next step would have been to verify train coil resistance and pulsing. February 7th, , But what you should be pressing on through the hole is the set lever, not the train wheel setting lever. After being shot by a paintball and having the paint find its way down my sleeve and onto my watch, i decided to open up the watch to give the watch a clean as the paint had found its way to underneath the crown. December 21st, , August 21st, 6. I do find that there is a fair bit of resistance when twisting the crown to set, which was not there before I removed and replaced the crown.

I did the same thing with the AR today, however when i put the crown back into place the watch was not working. The time now is Hattori VD53b Japan Quartz Chronograph – Not working after removing and putting back crown You may have interrupted power to the circuit. June 27th, , Any ideas as to what might be wrong? Seiko 5 SNK not regulated by putting crown up? Results 1 to 6 of 6.

I can still pull out the crown, once to set the date, and twice to set the time, but the movement does not run. Seiko 5 SNK not regulated by putting crown up? It is likely that this part was mal-positioned when you removed movemeht stem August 20th, 3.

Hattori SII Caliber VD53B

Is this normal or could this be the problem? June 27th, Any help is much appreciated Kind Mogement, AK. Originally Posted by BenchGuy. August 20th, 2.

  DRAMA SERIAL DAAG E NADAMAT LAST EPISODE

Japan Movements Movement VD53B Watch Quartz

If you have pushed on the latter, you may have caused it to disengage from the set lever so that it is constantly in contact with the train thus keeping the train stopped. December 21st, Hattori VD53b Japan Quartz Chronograph – Not working after removing and putting back crown You may have interrupted power to the circuit.

See page 7 in the link. By tzakiel in forum Seiko. Raketa Putting the watch back back on help! After being shot by a paintball and having the paint find its way down my sleeve and onto my watch, i decided to open wztch the watch to give the watch a clean as the paint had found its way to underneath the crown.

August 21st, 6. My next step would have been to verify train coil resistance and pulsing.

August 20th, 1. August 21st, 5. I’ve taken the crown stem out of movements before simply by pushing with a pin into the hole indicated to by an arrow and the word “push” and then sliding the crown and stem out of the movement.

The time now is By Andrew17 in forum Russian watches. January 18th, Hope you guys can help me out. Results 1 to 6 of 6. I don’t know if that is “normal” What appears to be the train wheel setting lever is bent in the area which appears in the crown release hole.

  PENDEKAR BUJANG LAPOK FULL MOVIE WARNA

I did the same thing with the AR today, however when i put the crown back into place the watch was not working. If continuity is good and if pulsing, then train blockage would be next on the list of faults to look for.

August 20th, 4. Any ideas as to what might be wrong? If the seals were incompetent, paint in the movement would cause failure Watchuseek recommends Chrono24the largest watch marketplace on the Internet. Sponsored Links Remove Advertisements.

Try a circuit reset. You may have interrupted power to the circuit.

Japan Movements Movement VD53B Watch Quartz | eBay

I do find that there is a fair bit of resistance when twisting the crown to set, which was not there before I removed and replaced the crown. The train wheel setting lever should be positioned vf53b that the train is blocked when the set lever is in position 2, then unblocks train in positions 0 and 1. Help Forgot your password?

February 7th, Similar Threads Putting an exhibition back on a quartz GS March 3rd, By sheldoncooper in forum Seiko.